Hi,
i work with EasyAVRv7 and all things are OK.
Only with my new prohect, where i use ATTiny 2323, i get error by writing programm to device.
I get this error: Can not synchronize device with programmer
THKS for answer
Stari
Can not synchronize device with programmer
- darko.ilijevski
- Posts: 581
- Joined: 21 Mar 2017 16:57
Re: Can not synchronize device with programmer
Hello,
Try reading about that issue on this LINK here, it's a post in our knowledge base.
Best regards
Try reading about that issue on this LINK here, it's a post in our knowledge base.
Best regards
BR,
Darko
Darko
Re: Can not synchronize device with programmer
Ah, sory. I forget on speed. Thks
- darko.ilijevski
- Posts: 581
- Joined: 21 Mar 2017 16:57
Re: Can not synchronize device with programmer
Hi, it's me again. All is working fine, but then, i haven't changet any settings about speed, i get the same error.
It's imposible to programm this chip again, also
I can'e erase chip.
No, i have more ATTINY2313 and with another, new one, all is working.
I don't understand, whaat can be wrong.
Dusan
It's imposible to programm this chip again, also
I can'e erase chip.
No, i have more ATTINY2313 and with another, new one, all is working.
I don't understand, whaat can be wrong.
Dusan
- dusan.poluga
- mikroElektronika team
- Posts: 780
- Joined: 02 Feb 2017 14:21
Re: Can not synchronize device with programmer
Hi,
By default when you get a new avr mcu it is configured to run with the internal oscillator.
When you create a new project clock settings will be set to a external clock generator that is usually used on our EasyAVR v7 boards.
When you create a new project the first thing that you should do is configure your clock source in the Project Settings.
Set the clock source to be the Internal oscillator.
I hope this tip will help you avoid these issues in the future.
Best Regards,
By default when you get a new avr mcu it is configured to run with the internal oscillator.
When you create a new project clock settings will be set to a external clock generator that is usually used on our EasyAVR v7 boards.
When you create a new project the first thing that you should do is configure your clock source in the Project Settings.
Set the clock source to be the Internal oscillator.
I hope this tip will help you avoid these issues in the future.
Best Regards,
Dusan Poluga.
Re: Can not synchronize device with programmer
Thks,
with internal oscilator all is Ok.
Regards
Stari
Dusan Petek
with internal oscilator all is Ok.
Regards
Stari
Dusan Petek