The ability to go back or jump to line number

[Maged A. Mohamed]

Hi,
Sometimes one write some where deep some typo mistakes a wrong value or instruction like LoWord instead of Lo, and want to correct that and do the correct steps
I know it is difficult to save the micro data so going back puts the correct data in place, but in many cases the mistake in area of assignment and going back will affect no results.

My wish is putting a goto line number and with a warning that the data in micro will not be modified and may not be correct, do it if you know what you are doing.

That will be easier than restarting compiler from the beginning..

Best regards

[biljana.nedeljkovic]

Hi,

I will forward your request to our development team and they will consider it.

If you want to go to specific line in the code, you can go to: Edit -> Goto Line, where you can type in the desired value. Also, instead of going undo, you can replace any symbol or word by Edit -> Replace.

Kind regards,
Biljana