I have bought both boards OOK TX and RX Click
But I'm unable to use the included library to make it work with my custom build board.
How do I translate the mikrobus library to work with my custom board?
How do I see the mikrobus library to adjust it to configure it to work with my custom boards?
The TX click uses an I2C chip, but I couldn't find anywhere the address of that chip, not even in the datasheet for the chip.
I have, however installed the mikrobus library and tried to compile the program, but it comes with this error:
Code: Select all
#error GENERIC BOARD DEF - Check if existing modules match your MCU
Can anybody help me, please.
Thanks