I have not found differences between new and old version ICD, a very long time with Step-over [F8], Step-Into [F7] or Step-out [Ctrl + F8].
Best regards.
Problem with ICD new version.
- slavisa.zlatanovic
- mikroElektronika team
- Posts: 1321
- Joined: 07 Apr 2009 09:39
Re: Problem with ICD new version.
Hi!
Improvement of mikroICD affects the PIC18 MCUs.
Please, try to step over (F8) Delay or Glcd_Image routines at some PIC18 MCU and you'll see what I'm talking about.
It is now done much faster!
Improvement of mikroICD affects the PIC18 MCUs.
Please, try to step over (F8) Delay or Glcd_Image routines at some PIC18 MCU and you'll see what I'm talking about.
It is now done much faster!
Best regards
Slavisa
Slavisa
-
- Posts: 2780
- Joined: 25 Dec 2008 15:22
- Location: Scotland
Re: Problem with ICD new version.
as advertised...
the advertising does not say... for PIC18 only!
EDIT:
to be fair, it does indicate on the beta page... http://www.mikroe.com/esupport/index.ph ... &newsid=25
We have introduced
ICD as a separate DLL module, and enhanced ICD code drastically. No more long waitings
when you hit Step-over [F8], Step-into[F7] or Step-out[Ctrl+F8].
the advertising does not say... for PIC18 only!
EDIT:
to be fair, it does indicate on the beta page... http://www.mikroe.com/esupport/index.ph ... &newsid=25
F8, F7, Step-out is real-time in mikroICDan operation when it is possible (P18 family)
Best Regards
Mince
Mince
Re: Problem with ICD new version.
For release this improvement will affect and P16 family,
also we have added step-out support for p16.
also we have added step-out support for p16.