I have tried to make a program for an ATMEL micro-controller and no luck to be had.
There seems to be tons of un- documented changes in the libraries now. and no end in sight...
I have switched back to the use of Bas-Comm for now. at least it works.
When will this get resolved?
Robert
Is this software even usable anymore?
-
- Posts: 145
- Joined: 14 Nov 2012 00:30
- Location: China
- Contact:
Re: Is this software even usable anymore?
Hi,
Can you please tell me which issues exactly do you have ?
Regards,
Filip.
Can you please tell me which issues exactly do you have ?
Regards,
Filip.
-
- Posts: 145
- Joined: 14 Nov 2012 00:30
- Location: China
- Contact:
Re: Is this software even usable anymore?
I have managed to work through this, but I have created a folder on the desktop for the project and no hex file exists in it after compilation time.
Where is the hex file located now?
Robert
Where is the hex file located now?
Robert
Re: Is this software even usable anymore?
Hi,
The HEX file should be in the folder where the project is.
Regards,
Filip.
The HEX file should be in the folder where the project is.
Regards,
Filip.
-
- Posts: 145
- Joined: 14 Nov 2012 00:30
- Location: China
- Contact:
Re: Is this software even usable anymore?
The hex file is not located in that folder. is there another place where it would be located?
-
- Posts: 145
- Joined: 14 Nov 2012 00:30
- Location: China
- Contact:
Re: Is this software even usable anymore?
I did play around in the settings and got it to make all files needed.
I did not find any example code in the folder for this board
Robert.
I did not find any example code in the folder for this board
Robert.