Hi,
cause i need JTAG Debug i try v2.0 Beta.
If i want to evaluate my Variables in AVR Studio i get the Message "Not in Scope".
Also i find a bad Code Generation with Optimizer Level 5. In this Sequence
LeftByte := 0;
MiddleByte := 0;
RightByte := 0;
is the Result
;HighSpeed.mpas,137 :: LeftByte := 0;
LDI 27, 0
STS _LeftByte+0, 27
;HighSpeed.mpas,138 :: MiddleByte := 0;
LDI 27, 0
STS _MiddleByte+0, 27
;HighSpeed.mpas,139 :: RightByte := 0;
LDI 27, 0
STS _RightByte+0, 27
The Result works for sure but the Generated Code is not good.
Hans
v2.00 Test
- nikola.kostic
- mikroElektronika team
- Posts: 433
- Joined: 11 Aug 2009 12:12
Optimizer can remove some variables if they are just declared and not used. Regarding your code generation note, we need more details so please create a support ticket and attach short code that can be compiled and demonstrates this problem (archived in zip or rar format) and we will inspect it.
You may create support ticket here:
http://www.mikroe.com/en/support/
You may create support ticket here:
http://www.mikroe.com/en/support/
Re: v2.00 Test
Hi,
after 6 Months nothing happend. My Problem still exists.
There is no really Support or solution.
Good by Me. One lost Custumer more.
after 6 Months nothing happend. My Problem still exists.
There is no really Support or solution.
Good by Me. One lost Custumer more.
- slavisa.zlatanovic
- mikroElektronika team
- Posts: 1321
- Joined: 07 Apr 2009 09:39
Re: v2.00 Test
Hi!
Please, send me your project. I would like to inspect it.
During the in circuit debugging you can see the value of local variables only when you step into routines using them.
Otherwise, "Not in Scope" message is displayed.
Best regards
Slavisa
Please, send me your project. I would like to inspect it.
During the in circuit debugging you can see the value of local variables only when you step into routines using them.
Otherwise, "Not in Scope" message is displayed.
Best regards
Slavisa
Best regards
Slavisa
Slavisa