ERROR : NOT ENOUGH RAM AND _LIB_GLCD.C

[weather]

hello

i am using micro c for compile my program which is about 37 KB to 40 KB and i am using device having flash memory upto 64 KB but somehow
,during compilation it gives error as below of not enough RAM. so if anybady have solution please REPLY me.

LIBRARY USED.
__Lib_Math.mcl" "__Lib_MathDouble.mcl" "__Lib_System.mcl" "__Lib_Delays.mcl" "__Lib_UART.mcl" "__Lib_CType.mcl" "__Lib_CStdlib.mcl"
"__Lib_GlcdFonts.mcl" "__Lib_Glcd.mcl"




LINE MESSAGE MESSAGE UNIT
NUMBER TEXT

204 362 Not enough RAM 'color' __Lib_Glcd.c
205 362 Not enough RAM 'rdata' __Lib_Glcd.c
205 362 Not enough RAM 'dama' __Lib_Glcd.c
205 362 Not enough RAM 'nema' __Lib_Glcd.c
206 362 Not enough RAM 'pointer' __Lib_Glcd.c
271 362 Not enough RAM 'color' __Lib_Glcd.c
272 362 Not enough RAM 'bit_mask0' __Lib_Glcd.c
273 362 Not enough RAM 'ddata' __Lib_Glcd.c
50 362 Not enough RAM 'x_pos' __Lib_Glcd.c
65 362 Not enough RAM 'local' __Lib_Glcd.c
39 362 Not enough RAM 'x_pos' __Lib_Glcd.c
104 362 Not enough RAM 'ddata' __Lib_Glcd.c
30 362 Not enough RAM 'page' __Lib_Glcd.c


THANK YOU

[WayneC]

Without knowing the part number of the MCU you are using I have to guess you have too many variables in your program. Gotta figure out a re-write to lower the variable count. While there may be 64K of ROM, the RAM is waaaay smaller.

[slavisa.zlatanovic]

Hi weather!

WayneC has a point... never the less you could send me your complete project to my email:
slavisa.zlatanovic@mikroe.com and I'll inspect it.

Best regards
Slavisa