spi-Ethernet card, "null" can not send
-
- Posts: 6
- Joined: 31 Mar 2011 01:06
spi-Ethernet card, "null" can not send
spi-Ethernet card, "null" can not send but sends all data from other
Re: spi-Ethernet card, "null" can not send
Hi,
Please, can you clarify your question and explain it in details ?
Regards,
Filip.
Please, can you clarify your question and explain it in details ?
Regards,
Filip.
-
- Posts: 6
- Joined: 31 Mar 2011 01:06
Re: spi-Ethernet card, "null" can not send
the fact that I want to See. There is a device. this device, tcp / ip with 4 pieces of picten send the hex number. pic circuit and performed the necessary software. I have read in the test data from my computer. The data is normally sent in the order "$fe $00 $01 $ff ". mycomputer "$ 00 " does not read the next data. but the data ""$fe $55 $01 $ff " such as when reading them all.
-
- Posts: 6
- Joined: 31 Mar 2011 01:06
Re: spi-Ethernet card, "null" can not send
I actually want to do. 18f452 spi Ethernet module and tcp / ip I want to send data over the 5 pieces. these are, respectively, ($ fe $ $ 01 $ 00 $ 26 ff) such as. When we tested it on the pc do not get $ 00 and later. but ($ fe $ $ 01 $ 55 $ 26 ff) lump of getting them all.
Re: spi-Ethernet card, "null" can not send
Hi,
Which development system, compiler are you using ?
Which SPi Ethernet board do you use and how did you connect it ?
Regards,
Filip.
Which development system, compiler are you using ?
Which SPi Ethernet board do you use and how did you connect it ?
Regards,
Filip.
-
- Posts: 6
- Joined: 31 Mar 2011 01:06
Re: spi-Ethernet card, "null" can not send
EASYPIC 5. SERIAL ETHETNET BOARD REV V2.40
Re: spi-Ethernet card, "null" can not send
Hi,
How did you test it ?
Did you use the examples given in the compiler ?
Have you set the network parameters on your computer according to the example ?
How did you connect the SPI Ethernet board to the EasyPIC6 ?
Regards,
Filip.
How did you test it ?
Did you use the examples given in the compiler ?
Have you set the network parameters on your computer according to the example ?
How did you connect the SPI Ethernet board to the EasyPIC6 ?
Regards,
Filip.