Editor EOL

General discussion on mikroC for dsPIC30/33 and PIC24.
Post Reply
Author
Message
rolfz
Posts: 30
Joined: 08 Jun 2006 23:40
Location: Switzerland

Editor EOL

#1 Post by rolfz » 10 Jun 2006 08:34

When scrolling across lines, the cursor does not jump to next line after the last instruction, but continues on the same line.

Any way to avoid this ? it is very unefficient as you always need to press enter to go to the next line, with risk that a not needed extra line is enterred.
Kind regards
Rolfz
Programming pic since 5 years, started with assembler, then C18 + C30. pic16f88, 16f877, 18f252, 18f4550, not 30f6010 +30f6014
Top
rolfz
Posts: 30
Joined: 08 Jun 2006 23:40
Location: Switzerland

#2 Post by rolfz » 13 Jun 2006 22:55

Found the solution in the Editor options.

-Scroll passed end of line
-Scroll passed end of file

flag removed solved my problem

Cheers
Rolfz
Programming pic since 5 years, started with assembler, then C18 + C30. pic16f88, 16f877, 18f252, 18f4550, not 30f6010 +30f6014
Top
Post Reply

Return to “mikroC for dsPIC30/33 and PIC24 General”