Hi,
HID Bootloader for PIC32Mx534 is working in MikroCPro for Pic32 but in NectoStudio 1.8.0 there is a timeout for hex file upload prematurely disconnecting the target device
Thanks,
Levi
Pic32MX534F064H Hid bootloader
Re: Pic32MX534F064H Hid bootloader
Hi,
You are referring to the HID bootloader application, not the bootloader code/firmware ?
Have you maybe recompiled bootloader code in NECTO Studio ?
Regards,
Filip.
You are referring to the HID bootloader application, not the bootloader code/firmware ?
Have you maybe recompiled bootloader code in NECTO Studio ?
Regards,
Filip.
Re: Pic32MX534F064H Hid bootloader
Hi Fillip,
Yes I am referring to HID bootloader application.In Mikro C Pro it’s working.In Necto Studio , the Hid Bootloader app is disconnecting from target device when I try to open the hex file.I didn't recompile the bootloader code in Necto Studio.
Best Regards,
Levi.
Yes I am referring to HID bootloader application.In Mikro C Pro it’s working.In Necto Studio , the Hid Bootloader app is disconnecting from target device when I try to open the hex file.I didn't recompile the bootloader code in Necto Studio.
Best Regards,
Levi.
Re: Pic32MX534F064H Hid bootloader
Hi,
I will see what is going on here, in the meantime please use bootloader application from mikroC PRO for PIC32.
I apologize for the inconvenience.
Regards,
Filip.
I will see what is going on here, in the meantime please use bootloader application from mikroC PRO for PIC32.
I apologize for the inconvenience.
Regards,
Filip.
Re: Pic32MX534F064H Hid bootloader
Hi,
I found out that the the HID Bootloader app from Necto is working differently than mikroBootloader.First you have to open the hex file then connect to target device,and after that Upload the file into microcontroller.But after 80% of the uploaded hex code .the Necto studio IDE and HID Bootloader app is crashing.
Best Regards,
Levi
I found out that the the HID Bootloader app from Necto is working differently than mikroBootloader.First you have to open the hex file then connect to target device,and after that Upload the file into microcontroller.But after 80% of the uploaded hex code .the Necto studio IDE and HID Bootloader app is crashing.
Best Regards,
Levi