Hi ,
I just migrate an old project from MikroC Pro for pic32 to Necto Studio 1.7.0 .The hex file is generated after project build, but unfortunately there is no way to programm the target device with mikroProg for Pic .The Programming alert box in the IDE is showing in the top , progress bar is endlessly running .... (nu timeout)
In the 3.Programmer Output window the message "Programing..." is showing but the programmer is not invoked.
I made another test , under the Programmer menu there is also an "Erase MCU" ,this function is calling the mikroProg programmer and everything is working as is expected.
Thanks ,
Levi
mikroProg Suite For PIC not working in Necto 1.7.0
Re: mikroProg Suite For PIC not working in Necto 1.7.0
Hi,
Have you set the path to mikroProg correctly ?
Please take a look at the following chapter in NECTO Studio help that explains how to setup the mikroProg :
https://help.mikroe.com/index.htm?context=940
Regards,
Filip
Have you set the path to mikroProg correctly ?
Please take a look at the following chapter in NECTO Studio help that explains how to setup the mikroProg :
https://help.mikroe.com/index.htm?context=940
Regards,
Filip
Re: mikroProg Suite For PIC not working in Necto 1.7.0
Hi Fillip ,
Sorry ,I found out that the antivirus software is "killing" the access of Necto Studio to the mikroprog command line , so there no programming was possible.
After the settings of antivirus policies, now I can program the target device , but sometimes the IDE is crashing before to start to program the device and , again ,checked the messages from antivirus and I found in antimalware quarantine the message "NectoStudio/crashpad/settings.dat" .
I have BitDefender antivirus installed on my laptop.
Thanks,
Levi
Sorry ,I found out that the antivirus software is "killing" the access of Necto Studio to the mikroprog command line , so there no programming was possible.
After the settings of antivirus policies, now I can program the target device , but sometimes the IDE is crashing before to start to program the device and , again ,checked the messages from antivirus and I found in antimalware quarantine the message "NectoStudio/crashpad/settings.dat" .
I have BitDefender antivirus installed on my laptop.
Thanks,
Levi
Re: mikroProg Suite For PIC not working in Necto 1.7.0
Hi,
Thanks for the detailed information, we will check this.
As for the workaround, is ti possible that you instruct BitDefender to omit this file from checking ?
Regards,
Filip.
Thanks for the detailed information, we will check this.
As for the workaround, is ti possible that you instruct BitDefender to omit this file from checking ?
Regards,
Filip.