Necto Studio 2 + legacy project + old usb library

[radug]

Hi there,

I have some question(s):
1/ I installed Necto Studio 2, I created a simple generic project for PIC32 using legacy code, I installed the USB Device & Host libraries via package manager:

NectoPackageManager.png (5.7 KiB) Viewed 1154 times

And now what?
I am confused since the package does not appear in list of available packages for my project...
How can I use the library?

2/ Can I disable the check for CodeGrip debugger when the application starts? It's kinda annoying because I do not have that specific piece of equipment.

3/ I noticed that I can flash an hex file perfectly without running mikroProg with elevated rights; why does Necto Studio need to run mikroProg with elevated rights?

4/ I cannot find the Interrupt Assistant. Where is it? The only way to write a ISR is to use the old compiler and import the routine into Necto? Am I missing smth.?

Thank you & Regards,
Radu G.

[filip]

Hi,

Which MCU did you use in the project ?

Regards,
Filip.

[radug]

Hi,

PIC32MX440F256H
I also tried PIC32MZ2048EFH100 ( on a Clicker 2 board ).

Regards,
Radu G.