EasyPic v7a: Error message when attempting to Run debugger

[thefossil]

Hi

I am very new to this board and also CodeGrip!

Having finally managed to get MicroP loaded and functioning with my new EasyPic 7a, I compiled the example code for blinking leds and it runs fine.
In order to test the ICD recompiled with the ICD option. Again the code loads fine, but when I attempt to 'Run' the code under debug I get the following message:

"MikroElektronika ICD
hardware not found"

What does this actually mean, and how can I run the debugger as I did with my previous EasyPic7?

Kindly advise, thanks

[filip]

Hi,

The EasyPIC v7a has CODEGRIP on-board programmer that is not compatible with the mikroProg Suite for PIC, hence the error.

I suppose you are trying to debug the code from the PRO compiler ?

Regards,
Filip.