CodeGrip can not find the device STM32 on Fusion for ARM v8 board.
Attached settings in CodeGrip and SW2 on Fusion board.
CodeGrip can not find the device STM32
CodeGrip can not find the device STM32
- Attachments
-
- TargetFailed_3.jpg (1.15 MiB) Viewed 769 times
-
- TargetFailed_2.jpg (92.06 KiB) Viewed 769 times
-
- TargetFailed_1.jpg (127.84 KiB) Viewed 769 times
Re: CodeGrip can not find the device STM32
Hi,
Can you please attach detailed photo of the whole board ?
Regards,
Filip.
Can you please attach detailed photo of the whole board ?
Regards,
Filip.
Re: CodeGrip can not find the device STM32
Thanks filip for your repply.
Attached board.
I changed another MCU STM32F407 and not find the device.
Regards
Attached board.
I changed another MCU STM32F407 and not find the device.
Regards
- Attachments
-
- TargetFailed5.jpg (598.44 KiB) Viewed 711 times
Re: CodeGrip can not find the device STM32. Fixed it
Error Codegrip on Fusion for ARM V8, Connecting to device failed .
Solution (in this case):
MCU options:
1.- Change setting Connection =Under reset and Halt on connect = Enabled.
2.- Power Off/On on Fusion Arm V8
3.- Target is detected.
Solution (in this case):
MCU options:
1.- Change setting Connection =Under reset and Halt on connect = Enabled.
2.- Power Off/On on Fusion Arm V8
3.- Target is detected.
Re: CodeGrip can not find the device STM32
Hi,
I'm glad that you have found a solution for your issue
Regards,
Filip.
I'm glad that you have found a solution for your issue
Regards,
Filip.