Codgrip Verification Failed

[khnor]

Hi,
I have a problem that Codegrip would not Verify MCU software correctly, if i use MikroProg it will verify correctly. I have also tried another Codgrip programmer but both CodeGrip programmers have the same verification error. Any suggestions how to fix this problem?

[filip]

Hi,

Can you please perform the firmware upgrade first and then try this again, follow these steps:
1) Connect your device
2) Open CODEGRIP Suite
3) Go to HELP > Updates > CODEGRIP
4) Click on the Scan Devices button
5) You have 5 seconds to toggle the power on your device (if you are using a development board simply press the power button twice, if you are using external CODEGRIP programmer, unplug and plug the USB cable)
6) After the 5 second countdown ends the device should appear in the list, simply click on the Update Firmware button and follow the steps until the end

Regards,
Filip.