STM32H743ZI - Scheme file description do not match

[_Chriss_]

Hi,

i have a problem with mikroC for ARM v6.2.0.
I would like to create a new project (STM32H743ZI), but if i edit the general project settings, click "OK" and open the settings again,
9 settings are lost.

PLL1 DIVP division factor, PLL1 DIVQ division factor, PLL1 DIVR division factor,
PLL2 DIVP division factor, PLL2 DIVQ division factor, PLL2 DIVR division factor,
PLL3 DIVP division factor, PLL3 DIVQ division factor, PLL3 DIVR division factor

If i save the settings in a "Scheme" and reload it again, an error message appears. (See attachement)

I would be glad, if this error is eliminated as soon as possible.

King regards
_Chriss_

[stefan.filipovic]

Hi Chriss,

Welcome to the mikroE forum.

Unfortunately, it seems that this problem is related to the IDE itself, so I will forward this to our developers, they will fix it as soon as possible.

Meanwhile, I'm sending you the workaround to this issue:

- Please replace the existing STM32H743ZI.mlk file with the mlk file from the attachment. You can find this file on the following path: c:\Users\Public\Documents\Mikroelektronika\mikroC PRO for ARM\Defs\
- After that, you should be able to save/load the clock scheme without errors, but you will need to set each of these dividers (DIVP, DIVQ, DIVR) to a value less than one of the value you actually want to set.
For example, if you want to set PLL1 DIVP to 50, you need to set it to 49, and it will be actually set to 50.

I apologize for the inconvenience caused by this.

Kind regards,

[Toley]

Hi Stefan,
I have the same problem with STM32H743VI. Do you have the corrected mlk file for STM32H743VI ?

Thank you.

[stefan.filipovic]

Hi Serge,

You can use the mlk file I've posted, just change the name of the file to STM32H743VI.mlk, and the name of the device at the file very beginning to STM32H743VI.

Kind regards,