matrix RGB and clicker2 pic18fk with mikroC

[DusanINN]

Regards to all,
I recently bought a matrix rgb and a development board clicker 2 pic18fk. I have successfully compiled example from githab and downloaded it to microcontroler. I also put LED1 to change the state each time when the program step in another method. I use original power supplay and the flat cable is in correct place -red on triangle.
Matrix RGB do not light at all !!! But LED1 are changing the state. That show me that firmware do not stack enywhere and there are some comunication with matrix driver.
I would very much appreciate any kind of help.

[filip]

Hi,

Can you please attach the photo of your hardware along with your project ?

Regards,
Filip.