Configuring project to fit mikrobootloader flash tool

[mgrumic]

Hi all,

I'm having trouble downloading firmware (UART/Led blink example) to Flip & Click with PIC32MZ chip on it.
I'm using mikrobootloader v2.4.0.0. The problem is that mikrobootloader is complaining about overwriting bootloader area.

So I've tried to find some information about mikrobootloader (where it resides, where should be FW reset interrupt and start address etc).

I was unable to find mentioned information.

So my question is, how do I configure project to be "mikrobootloader compliant"?

If you need I can attach my hex file and .c file.

Sincerely,
Marko

[mgrumic]

I haven't read that it goes to moderator first, so this can be closed/deleted whatever, there is a post that is "almost" the same as this one.