A common use of CAN communication works well. (Filter, interrupt)
Only the ID starting with the 0x2 would like to set up to enter the interrupt.
The ambiguities of how to use can set mask.
- lana.arsic
- mikroElektronika team
- Posts: 1715
- Joined: 15 Jan 2016 12:50
Re: The ambiguities of how to use can set mask.
Hi,
I'm sorry, I'm not sure if I understand you well,
can you please explain me more the question?
Kind regards,
Lana
I'm sorry, I'm not sure if I understand you well,
can you please explain me more the question?
Kind regards,
Lana
Re: The ambiguities of how to use can set mask.
When there are multiple products on a single CAN BUS handed
Now it enters the interrupt for every packet received.
Using a masking
When the interrupt is received, the ID corresponding to the 0x2XX
I would like to use a form to enter.
Now it enters the interrupt for every packet received.
Using a masking
When the interrupt is received, the ID corresponding to the 0x2XX
I would like to use a form to enter.
- lana.arsic
- mikroElektronika team
- Posts: 1715
- Joined: 15 Jan 2016 12:50
Re: The ambiguities of how to use can set mask.
Hi,
You should be able to work with multiple CAN nodes.
You can check ID of each node and make sure that the bus is properly terminated.
Also, you will need to take care that all nodes work on the same frequency.
If you still have issues, can you post the minimal example which represents it?
Did you try CAN example from the compiler?
Kind regards,
Lana
You should be able to work with multiple CAN nodes.
You can check ID of each node and make sure that the bus is properly terminated.
Also, you will need to take care that all nodes work on the same frequency.
If you still have issues, can you post the minimal example which represents it?
Did you try CAN example from the compiler?
Kind regards,
Lana