MikroElektronika Forum

I still don't understand about how to save commands onto the SpeakUp Click.
Uros has stated that "Every time you hit the "Upload project" button, the previously saved commands are erased"

I am trying to save the words "TWO SEVEN" and I am saying it slightly differently each time [to improve reliability]
I am saving each different Voice Command "TWO SEVEN" as 271 272 273 274 ... and so on ..
Each time I am assigning Pin IO7 to a 3 minute PULSE and pressing the Upload button
Are you saying that each time I press the UPLOAD button the previous "TWO SEVEN" recordings are erased ... ?
This is very confusing ... please clarify

Hi Stephen,

You are right, cause every time you press "Upload project" the application programs MCU on the SpeakUp click,
so it erases previously firmware on the MCU.

You should press "+" button, and add all commands to one project, and then upload it.

Best regards,

Uros