Heart Rate 3 and 8 Source Code needed

[Jamez]

Hello together,

I know that you don`t provide Software Support for Arduino but since I can`t open your mpkg files for some reason, is there a Chance, that you can send me the Heart Rate 3 and 8 Source Codes, so I can build my own libary?
And if possible some examples ? (Or explain me how to unpack the mpkg files on windows ?)


P.S
I already got the Source Code for the Heart Rate 5 from the other topic , thanks for that.

[filip.grujcic]

Hi,

You can find the source code for Heartrate 3 on our Github:
https://github.com/MikroElektronika

I will have our developers upload the source for the other 2 Click boards you've asked for in the other thread.

Kind regards,

[Jamez]

Okay

I am waiting for the other Codes and aswell the Heart-Rate 8 please.

[Jamez]

And if possible for the Mikroe 3566 (BME388).

If you want I can send you the Arduino (C)-Libaries after aswell

[filip.grujcic]

Hello,

Attached is the source for Pressure 5.

Regards,

[Jamez]

Hey , thanks so far.

Is there a chance to get the C-Code/Sample Code for the Heart Rate 5 aswell ? Either here or via E-Mail

And I just read:
SW1 MODE SEL
Photo-diode type selection (anode): left position HRM (P), right position SpO2 (O)

Does this mean, that the Heart Rate 5 can only measure HRM OR SpO2 ? Or can it measure both at the same time ?
If the HeartRate 5 is not able to measure both at the same time, can you suggest me another sensor for the wrist ?


Kind regards
Jamez

[jovana.medakovic]

Hello Jamez,

Unfortunately, you cannot measure HRM and SpO2 at the same time using Heart rate 5 click board.
However, you can read about Heart rate click board:
https://www.mikroe.com/heart-rate-click
Maybe it can be interesting for you.

In the attachment, you can find the source code of this click board.

Kind regards,
Jovana

[Jamez]

1. Is it a problem of the sensor (sfh 7072) itself ? Or is the problem based on the pcb soldering ?
2. I guess the Heart-Rate-Click is only for the index-finger but not for the wrist ? (Since green led`s would be better) Or am I wrong ?

Thanks for the C-Files, best Support keep going like this

Kind regards
Jamez

[Jamez]

Can you tell me how to wire the Heart Rate 5 Click to an Microcontroller ?

Do I just need 3,3V/5V, GND, SDA and SCL if I work with I2C ? Or do I need to put another pin to GND or VDD ?