Mikroprog debug with M4Clicker Problem
Posted: 27 Jul 2022 09:48
Hi!
The following problem occurred with the Mikroprog debugger when using the M4Clicker module:
Programming and debugging works flawlessly on the EasyMxProV7 development board with Cortex M3 processor (using external debugger, but also with internal debugger).
The programming of the M4Clicker module works basically, but I can't debug it because I get a "No Device" error message and also the error message "MikroElektronika ICD hardware not found".
Mikroprog software version: v1.61
Debugger Firmware version: v2.j40.S0 (the newest from ST)
Any ideas?
Thanks in advance!
pogi
The following problem occurred with the Mikroprog debugger when using the M4Clicker module:
Programming and debugging works flawlessly on the EasyMxProV7 development board with Cortex M3 processor (using external debugger, but also with internal debugger).
The programming of the M4Clicker module works basically, but I can't debug it because I get a "No Device" error message and also the error message "MikroElektronika ICD hardware not found".
Mikroprog software version: v1.61
Debugger Firmware version: v2.j40.S0 (the newest from ST)
Any ideas?
Thanks in advance!
pogi