HI,
I am using PICflach2 ICD programmer. and want to program a PIC16F819 . I can program each chip only once !!! I have tried on 2 brand new chips and one I had before and was for another project but same result!
Both power type checked ( with usb and external ) same result.
What to do?
-Device detected: PIC12F508 !!!
Re: -Device detected: PIC12F508 !!!
Try putting a pull-down resistor from PGM pin (RB3 pin 9) to ground
Anything 1k Ohms to 10K Ohms should do
This will prevent the PIC from going into low-voltage-programming mode.
Anything 1k Ohms to 10K Ohms should do
This will prevent the PIC from going into low-voltage-programming mode.
Start every day with a smile...... (get it over with)
Re: -Device detected: PIC12F508 !!!
I checked with PICKIT 3 ( clone version) with no problem on all of them!
Re: -Device detected: PIC12F508 !!!
Hi,
Can you please attach schematics/photos of your connections ?
Regards,
Filip.
Can you please attach schematics/photos of your connections ?
Regards,
Filip.
Re: -Device detected: PIC12F508 !!!
same problem here! what is the problem!?