#5
Post
by abhijitrashinkar » 23 Feb 2022 15:41
Hello! Hexreader
good evening
Kindly excuse me if i am writing on the wrong note, may i request you to point out my mistake if possible.
I am using EasyPIC V7 and also i have installed MikroProg Suite V2.90, my board has a firmware V1.11.11.1 and everything was working until i need to use PIC18F26K42 and PIC18F27K42 (because of 12Bit ADC), i was answered by Filip (MicroE person) to upgrade the firmware from the suite, i tried to upgrade the firmware but every time it is interrupted due to some errors and then i receive the EMPTY error at the end.
No i am left without any firmware in the EasyPIC, so as per Filip advise i installed the firmware by the file he provided, somehow i managed to install the firmware but again the old version (V1.11.11.1), unfortunately this firmware is not able to program the above mentioned chips.
To solve this problem i purchased MikrpProg 764, but again the same "History Repeat" this device also has a firmware with version V1.11.11.1, so i am again back to the same square. Honestly i am afraid the update the firmware of this new device, rather confused if i should perform the upgradation or not.
Kindly excuse if i have posted my doubt on wrong heading, i will be very grateful if you could answer my doubt/problem, unfortunately i am not receiving any answer from the support team for the moment.
DOUBT: is it possible to get the firmware file like what Filip shared for the EMPTY error, that will be easy to solve the problem quickly.
Thank you.
Regards
Abhi