Hello!
I'm just starting with MCU programming. I use the Mikroprog Programmer together with clicker-2-Board for PIC32MX
The mikroProg Suite V2.60 recognizes the Mikroprog but if I do any action like READ BLANK ERASE ... I always get the error:
MCU voltage error! (3,66 Volts)
If I measure Vcc with an oscilloscope, you can see a slight increase to max. 3.4 Volt
In IDLE state I always have about 3,2 Volt
I use Mirkoprog HW: mikroProg v01.16.12.21 and newest Firmware 2.11
The clicker-2-Board is powered over USB or via Akkupack or both (always the same error)
Whats wrong?
first project - MCU voltage error
first project - MCU voltage error
- Attachments
-
- Blank test
- Blank.jpg (109.15 KiB) Viewed 3194 times
-
- Idle state
- Idle.jpg (105.85 KiB) Viewed 3194 times
- dusan.poluga
- mikroElektronika team
- Posts: 780
- Joined: 02 Feb 2017 14:21
Re: first project - MCU voltage error
Hi,
Do you have this behavior when your try to program any other development system or does this happen only with this clicker 2 board?
How long do you have this mikroProg programmer ?
Please inspect the programming cable of the programmer.
Best Regards,
Do you have this behavior when your try to program any other development system or does this happen only with this clicker 2 board?
How long do you have this mikroProg programmer ?
Please inspect the programming cable of the programmer.
Best Regards,
Dusan Poluga.
Re: first project - MCU voltage error
it is the only development system I have. The clicker-2-Board and the programmer are new.
Re: first project - MCU voltage error
It is the only development system I have. The clicker-2-Board and the programmer are new.
- dusan.poluga
- mikroElektronika team
- Posts: 780
- Joined: 02 Feb 2017 14:21
Re: first project - MCU voltage error
Hi,
Can you please set your mikroProg window like shown on the image and try programming it.
Best Regards,
Can you please set your mikroProg window like shown on the image and try programming it.
Best Regards,
- Attachments
-
- prog.png (57.07 KiB) Viewed 2164 times
Dusan Poluga.