mikroICD can't Step (into, over, out) and Run to cursor

General discussion on mikroProg™ programmer and debugger and mikroProg Suite software as well.
Post Reply
Author
Message
alexandrecvl
Posts: 3
Joined: 13 Sep 2012 08:29

mikroICD can't Step (into, over, out) and Run to cursor

#1 Post by alexandrecvl » 07 Jul 2017 20:45

Once I start debugging mode (yes, I know that Build type must be ICD Debug and Debugger must be mikroICD) it shows the PC at a constant value and does not give me options to neither step through the code or run to cursor. I can just start, pause, and stop.
Top
User avatar
lana.arsic
mikroElektronika team
Posts: 1715
Joined: 15 Jan 2016 12:50

Re: mikroICD can't Step (into, over, out) and Run to cursor

#2 Post by lana.arsic » 10 Jul 2017 12:24

Hi,

Did you install compiler and mikroProg Suite explicitly as administrator
(unzip folder from our website, and then right click -> Run as Administrator)?

Can you tell me which hardware and MCU are you using?
Can you attach the minimal example where the issue occurs?

Kind regards,
Lana
Top
Post Reply

Return to “mikroProg™ programmer and debugger”