Problem with “mikroProg”, USB programmer on Windows 10

[MisterObe]

I have a problem with “mikroProg”, USB programmer.

I use this programmer : https://shop.mikroe.com/mikroprog-pic-dspic-pic32
I work on Windows 10
I installed by downloading the site Microship drivers for Windows 7 - 64 bits.

The device was not recognised. I can not Selecting the device in the microProg Suite USB menu gives this:


Can you help me please.
Thank you in advance

[dusan.poluga]

Hi,

Try rinning mikroProg Suit as administrator.
You can do that by right clicking on the shortcut and by clicking on Run as Administrator.

Best Regards,

[MisterObe]

Hello mikroE,

Problem Solved !
Thanks for your reply

Regards,

[MisterObe]

But when I try to write my program on my MCU, I have this warning displayed
It detects another MCU (pic12F508), the MCU that is detected is different than the MCU I use (PIC16F1939)
Do you know where this error may come from please?

Then, when uploading is finished on my MCU, i have a error ( cf the picture).

Can you help me please.
Thank you in advance

[dusan.poluga]

Hi,

Please double check connections between mikroProg and your micro controller.
This error is often caused by loos connections.

Best Regards,