I am using the Mikroc Pro for arm with a Tiva V8 board TM4C129XNCZAD arm. I have make the necessary update on the board firmware and i am at version 1.6.0. The CodeGrip was working perfectly and now the codegrip fails to verify the program after the writing.
I have tried to upload every example like Uart, LedBlinking and i get the same result
Thats the codegrip output
Code: Select all
Starting operation...
Connecting to target MCU...
Erasing MCU...
Writing MCU...
Verifying...
Verification failed.
Chip is halted.
Disconnected from target.