lv_picflash select in preferences

[jpc]

it would be convenient to have the possibility to select lv_picflash as default programmer to be set in the preferences , now F11 is limited to dsPICFlash 1 /2 , when working with LV24-33 board i would like to change this

[marko.ziv]

Hi,

you may already know this but nevertheless here is the info, mikroPascal for dsPIC30/33 and PIC24 starts up
dsPICFlash or LvPICFlash accordingly to the MCU you have selected in your project. Basically, it should start up
dsPICFlash for PIC30F family, or LvPICFlash for PIC24 and PIC33 family of MCU. I have run a quick test (just to be sure)
of this and it is working as it should.

Best regards

[jpc]

i did NOT know , thanks for explaining. The only question left in that case is what will happen if i have both EasyDSPic and LV24-33 board connected to system but that is not urgent.

[marko.ziv]

Hi,

when you have two boards connected to your computer all you need to do is to select the appropriate board.
You can do this by clicking on the USB sign in your dsPICFlash or LvPICFlash (depends on what software are you using at the time).
When you click on the red USB sign (in the right bottom corner) you will be presented with a choice which board you want to use.

Best Regards