auto osc speed calculation

Post your requests and ideas on the future development of mikroC.
Post Reply
Author
Message
arhimed
Posts: 15
Joined: 14 May 2008 04:06

auto osc speed calculation

#1 Post by arhimed » 08 Jun 2008 14:25

AFAIK the OSC speed that we need to setup in project properties is used by internal mikroC libraries (especially Delay_* and software* functions). Now, with all internal osc capabilities and PLL to multiply internal/external osc, it would be *very helpful* if we are to enter only value for external osc, and then the IDE can recalculate the real speed according to fuses set.
Top
arhimed
Posts: 15
Joined: 14 May 2008 04:06

Re: auto osc speed calculation

#2 Post by arhimed » 28 Jun 2008 00:16

arhimed wrote:AFAIK the OSC speed that we need to setup in project properties is used by internal mikroC libraries (especially Delay_* and software* functions). Now, with all internal osc capabilities and PLL to multiply internal/external osc, it would be *very helpful* if we are to enter only value for external osc, and then the IDE can recalculate the real speed according to fuses set.
or if there is a possibility that mikroe team can make something similar to "Visual Initialiser" that comes with mplab .. at least for setting up some main config bit's like oscillator freq?
Top
Post Reply

Return to “mikroC Wish List”