Good morning,
I need help from any members.
I just have bought the Easypic v7 Fusion for DSPic.
In this case, I have installed drivers for the development board. Thus, I have installed
USB18PRJ.sys driver and USB18PRJ.inf for windows 64 bits OS because I work with windows 10 OS.
I have restarted my computer...
But, when I go to the device manager, the driver doesn't appear.
So, I have added the driver manually within the device manager. And I obtain the error code 10: device can not start.
I tried to disable software signature but I am experiencing the same problem.
Thank you very much for your help. Sorry my english isn't perfect.
Dominique
troubleshooting with USB18PRJ.sys file
Re: troubleshooting with USB18PRJ.sys file
Hi,
Have you tried installing the drivers from the following link as Admin (right-click and choose Run As Admin) :
https://download.mikroe.com/setups/driv ... rivers.zip
Once you connect the development board, does the Windows detects it ?
Try also disabling the User Account Control from the Device Manager.
Regards,
Filip.
Have you tried installing the drivers from the following link as Admin (right-click and choose Run As Admin) :
https://download.mikroe.com/setups/driv ... rivers.zip
Once you connect the development board, does the Windows detects it ?
Try also disabling the User Account Control from the Device Manager.
Regards,
Filip.
Re: troubleshooting with USB18PRJ.sys file
Hi Filip,
I have disabled the user account control and installed the drivers as administrator user but the problem does always exist. Thanks for your help. Best regards, Domi1804
I have disabled the user account control and installed the drivers as administrator user but the problem does always exist. Thanks for your help. Best regards, Domi1804
Re: troubleshooting with USB18PRJ.sys file
Hi,
Can you please attach relevant screenshots from the Device Manager and mikroProgSuite for PIC once the board is connected to PC ?
/
Regards,
Filip
Can you please attach relevant screenshots from the Device Manager and mikroProgSuite for PIC once the board is connected to PC ?
/
Regards,
Filip
Re: troubleshooting with USB18PRJ.sys file
Hi Filip,
I have found the cause of the problem.
A piece of hex code inherit to TFT was the cause of the troubleshooting.
Best regards,
Domi1804
I have found the cause of the problem.
A piece of hex code inherit to TFT was the cause of the troubleshooting.
Best regards,
Domi1804