Spectrometer click (MIKROE-4165) and arduino

[iforire]

Dear all,

I'm trying to read the 11 channels of the MICKROE-4165 spectrometer Click using an Arduino board (I've tested Arduino Nano and MKR 1000) without sucess until now.
My programming skills are very low, so I tried to use existing libvraries for other commercial sensors that are based on the AS7341 chip (like the MIKROE-4165), but it did not work.
I saw there are some library available here using IDE i'm not at all familiar with. Would it work with an arduino board? My problem is that I have other sensors that I've already managed to use using the Arduino IDE.
What would you suggest me to do?

Thanks a lot,
Regards

[IvanJeremic]

Hi,

I have answered your question in the forum in the link below:
viewtopic.php?f=12&t=79741&p=316091#p316091

Regards,

Ivan.