I'm converting an application to Mickrobasic that uses the PI24FJ128GA204 on the Microchip PIC24 Curiosity board.
The code uses the EPMP on that chip to drive an LCD display using a circular buffer and timer.
So far so good except for the following:
Code: Select all
dim LCDCMD as word absolute 0x8000 ' RS = 0 For each address, bit 15 is set to trigger EDS. (See datasheet)
dim LCDDAT as word absolute 0x8002 ' RS = 1
From what I can tell, the area above 0x7FFF is undefined in the .mlk file for that chip.
Is this function unimplemented in Mikrobasic?
If so, how would I attempt this ?
Thanks,
Jerry