Errors starting debugger

[Rubbotron]

After I build and program (Ctrl-F11) with "ICD Debug" turned on in Project Settings, when I press F9 to start the debugger I get two error message windows:

Error1.JPG (12.45 KiB) Viewed 3905 times

Error2.JPG (12.63 KiB) Viewed 3905 times

"mikroICD: -Error Starting Debugger -PIC Clock Error. OK" and "mikroElektronika ICD hardware not found. OK."
I am using the EasyPIC Fusion V7 with the 24J128GA310 MCU board with mikroBasic Pro for dsPIC version 6.21 and mikroProg Suite for PIC v2.34. I have no problems if I build and program Release software. It flashes the micro and runs the program.
I have the same problem with a mikromedia workStation v7 with a mikromedia for PIC18FJ module. Since I am a beginner I feel certain I'm doing something wrong but I can't seem to figure it out. I tried using different USB ports and a different computer but it still doesn't work. I opened a support ticket on it last June, #XBB-878-98389, but we were not able to find the cause. HELP!

[Aleksandar.Mitrovic]

Dear Rubbotron,

Have you tried to reinstall drivers for the board in install them as administrator?
First remove them like on the picture1:

Picture1.png (46.18 KiB) Viewed 3861 times

, and install them like on the picture2:

Run as administrator.png (22.6 KiB) Viewed 3861 times

Regarding the ticket #XBB-878-98389, I can see that my colleague have suggest you couple of things but you didn't reply to it.
Can you please answer on that ticket?

Kind regards,
Aleksandar

[Rubbotron]

Thank you for the reply, Aleksandar. I did reply to your colleague's email with all of the information she requested. I also tried your suggestion but it did not help. I sent a lot more information in my latest reply to Biljana but I thought I'd include two snapshots in this post. I've captured the programs I've installed as well as the USB Driver details screen.

[biljana.nedeljkovic]

Hello,

As we have started the conversation via tickets, I suggest to continue it that way.

If someone from our community had similar issue maybe they will help on this topic.

Best regards,
Biljana

[Rubbotron]

Biljana solved this one for me. I'm typing the answer here so that someone else with a similar problem has this solution.

I had to go to Project, Edit Project, and then set the Emulator Pin Placement to "Emulator functions are shared with PGEC2/PGED2." The default setting, PEGEC1/PGED1, for the MCU P24FJ128GA310 caused the debugger not to function.