Error in config word of dspic33fj128mc802

[alcidesramos]

Hello in this post:
http://www.mikroe.com/forum/viewtopic.php?f=106&t=34089

I believe that the problem if the mikroprogram suite, and you send me a new .exe.


But the trust probelm is the configuration word in mikropascal pro for dspic.


I buy the pickit3 and note the problem.


I invited make this: make new project with dspic33fj128mc802.

in project edit edit change the watchdog bit enabled and see the value configuration register(FWDT) then change wacthdog bid disabled, and note that no change.


The same happend with motor control PWM config bits: if you toggle value the configuration register (FPOR) not chage)

then i cant config this bits, this it big probelm.

I have to config again in pickit3 for my program work oks.

i send the image of bit i have to chage in pickit3 software.
if i try to program with mikroporgsuite, it the same i have to chage the bit of watchdog and the motor control pwm pin mode.
i send image with rematk this bit with other color, if i chang manual and program then my program work oks.


The problem is in mikropascal that the chage in this bit not take efecct.

Please work in this solution.


Kind Regard.

Alcides Ramos.

[alcidesramos]

Please take this into account for the nex relaese;




kind regard

[filip]

Hi,

We will have this in mind for the next release.

Regards,
Filip.

[alcidesramos]

OK great work.



Kind regard.