Hi everyone,
I use my custom board that included mikro C with Visual TFT, dsPIC33EP512MU810, FT810 and 40 pin TFT display, and mikro SD card. there is no problem in my custom board. My problem is just start up of FT810. when i give DC supply to system, FT810 IC can not make correct start. Firstly, FT810 show last screen in it's RAM, after that resetting and correct working. and in this video, I tried 4 times reset via mikroprog suite, you can see failure start up in linked video. I want to solve this FT810 resetting when start. I added a youtube video link as below. Also I added my test project files. is there anyone who can help me?
FT810 Start up problem
FT810 Start up problem
Last edited by MedBoy on 06 Dec 2021 20:43, edited 2 times in total.
Re: FT810 Start up problem
This is my 3th message about my problem. you can write a message or give an answer if you do not mE Team! I check everyday my post if there is an answer!
Re: FT810 Start up problem
Hi,
I apologize for the inconvenience caused by this.
Can you tell me does this happen with every project that you create using Visual TFT or just the one attached ?
Regards,
Filip.
I apologize for the inconvenience caused by this.
Can you tell me does this happen with every project that you create using Visual TFT or just the one attached ?
Regards,
Filip.
Re: FT810 Start up problem
Hi Filip. Thanks for your reply. This problem happen my every visual tft project. When i draw my custom board, i took reference your EVE FT800 board. Did you see any wrong code in my test programme?
Also i should say this; when i restart, other pins output level changed from low to high or otherwise. may be my problem should be software config settings.
Also i should say this; when i restart, other pins output level changed from low to high or otherwise. may be my problem should be software config settings.
Re: FT810 Start up problem
Hi,
I see that you call FT functions at the beginning. If you remove them and leave just what VTFT generates does the issue persist ?
Regards,
Filip.
I see that you call FT functions at the beginning. If you remove them and leave just what VTFT generates does the issue persist ?
Regards,
Filip.
Re: FT810 Start up problem
I ignored with "//" that " InitVTFTStack();", the software does not work. because thera are initilizations in " InitVTFTStack();". also i did not start with this code, your visual tft creat that starting and suggest to me.
Last edited by MedBoy on 20 Sep 2021 22:40, edited 1 time in total.
Re: FT810 Start up problem
Hi,
I was actually referring to the following function calls :
Regards,
Filip.
I was actually referring to the following function calls :
Can you use only functions generated by the Visual TFT ?FT810_Screen_BeginUpdateCP();
FT810_Screen_LogoCP();
Regards,
Filip.
Re: FT810 Start up problem
Hi Filip. Excuse me for misunderstanding
I see you correctly now. And tried that you said, but unfortunately make again reseting like youtube video.
Resetting and white screen.
I see you correctly now. And tried that you said, but unfortunately make again reseting like youtube video.
Resetting and white screen.