Hi,
I just want to confirm that I see the same issue: However, as soon as I scroll down the missing icons appear.
regards,
Sebastian

Hi, I'm trying to get some rough numbers about how much time is needed to render on the connected touch screen. HW: Fusion for STM32 v8 STM32F407ZGT MCU card TFT Board 4 Capacitive SW: mikroSDK setup with Necto Designer I measured the time it takes for vtft_process by reading a timer value before an...

Hi, I'm trying to get a CAN interface running on a Fusion for STM32 v8 board and have a few questions: It seems like e.g. the mcp2542-click should provide a CAN transceiver which should directly be controllable via the STM bxCAN peripheral, is this correct? The corresponding example mcp2542 seems to...

Hi, should the code generated by the timer calculator work with Necto studio? I get an error "Undeclared identifier 'NVIC_IntEnable' in expression". According to this post: https://forum.mikroe.com/viewtopic.php?f=238&t=77711&p=309578&hilit=timer#p309578 the NVIC_... functions were not implemented -...

Hi Darko,
I wasn't aware where to set the clock settings - my fault for not reading the documentation well enough. With the correct clock settings the ethernet example works so far (the LEDs are blinking and it's pingable).

Thanks for your help,
Sebastian

Hi, I'm having troubles getting the Ethernet_Demo running with the following setup: development board: Fusion for STM32 v8 mcu card: STM32F407ZG necto studio 1.8.6 with following setup selected: Fusion for STM32 v8 mikroC AI for ARM STM32F407ZG CODEGRIP 168MHz No Display According to the instruction...