what if I use 18F4550? How I design for 18F4550. What do you mean by socket 1 and socket 2?

Hey, Thank you for your comment. I am not asking about the circuit diagram. I am asking about the respective pin configuration for the click board to the microcontroller interface ( esp. 18F2550).

Hello,
Can you explain the PIN diagram of mikroBUS used for the click (breakout boards). If click boards are directly interfaced with the StartUSB for PIC then pin AN, RST, CS, SCK, MISO, MOSI, PWM, INT, RX, TX, SCL, SDA are which PIN ( for the StartUSB for PIC board)?

Thank you.

Hello Thank you for your reply. I want to make an portable programmer like uprog http://mdiy.pl/uprog-maly-szybki-przenosny-programator-avr-z-sd/?lang=en . The main application is to program 16F and 18F microcontroller programming. This programmer is targeted to hobbyist. The hex file is copied to t...

Hello,

somebody can share the source code of the USB HID Bootloader host software ( PC side used for the HEX file uploading). How can I make my own software in C#. I want some modification in the main software for my board,
Thanks

Hello All, Can anyone explain me or direct me how the JDM programmer work and is there is simple C-code is available for the programmer software. I want to understand how to read the hex file and how to write the hex file to the PIC microcontroller. also, how can I erase a PIC microcontroller using ...

Hello, Thank you for your replies. As this is my first project and after this I will learn the PIC. As attached program, I am confused with the settings. Can you share the hex code for the PIC 18F4550 USB hid Bootloader for 8MHz external crystal. Can you suggest me any good tutorial for the basics o...

Thank you for your support. When I open this project file in my friend's computer the frequency shows 38 MHz but you mention 8MHz. Which one is correct? When I change the frequency to 8MHz the hex code will generated; This hex file I will use? or other settings are required?

Thanx.

Hello All, I am new to PIC. To learn the PIC microcontroller I want to burn a bootloader to 18F4550. As for the beginner, I think I must use bootloader instead of ISP programmer. There are many posts, but no one share the exact configuration setting for 18F4550. How can I change the configuration fo...