Dear SRDJAN,
Please send me the MMC libraries.

Thanks.

native value for boolean type is "0" or "1". Use those zero or non zero values to represent the boolean status

Clock: 10 MHz crystal (PLL disabled)
how about the on-board ethernet controller, why it warms?

This board eats a lot of current (~200 mA) and the ENC28J60 Ethernet Controller warms up over the rest of ICs.
pin port LED disable, LCD disable, dsPIC30F6014A only.
The on board programmer operates normally, but is the power consumption OK?

I would like to have libraries for access to USB flash disk on Windows OS

Please check the libraries for the dsPIC30F6014A
ByteToStr() dont exist

Please check the routine Vdelay_ms() this routine dont work and it causes stability problem

PIC: 16F876
clock: 20 MHz

Check the 5v regulator voltage, try to connect extern power supply, maybe is wrong. USB dont supply enough current. First, CHeck voltage, after that drivers and Software

If I write data to flash and EEprom alternating between these data Flash is corrupted. Device: dsPIC30F6014A Clock: 10MHz crystal I tried to record data from UART port and save to flash and eeprom. if I use Eeprom only or Flash only the program has been successfully but If I combine between these th...

Thanks!!

With the libraries for MMC Card is posibble to search and find files.
But if I wish to show a complete list of files with this libraries I can't
Because I dont know the names of files and I need to read the information inside

I would like to be able to change the LIBRARIES source code
allowing the user to development embedded programs.

mikro dsPICBasic test: I have been built successfully a program test for EasydsPIC3 : led blinking for 1 second timing. Oscillator config H2PLL4 (crystal 10 MHz). After reset button, the program works fine. But after power down the board and power up again the led blinking operates at diferent timin...

mikro dsPICBasic test: I have been built successfully a program test for EasydsPIC3 : led blinking for 1 second timing. Oscillator config H2PLL4 (crystal 10 MHz). After reset button, the program works fine. But after power down the board and power up again the led blinking operates at diferent timin...

mikro dsPICBasic test: I have been built successfully a program test for EasydsPIC3 : led blinking for 1 second timing. Oscillator config H2PLL4 (crystal 10 MHz). After reset button, the program works fine. But after power down the board and power up again the led blinking operates at diferent timin...